ZEN and BELOADER FIX?!

bobbarka

Ive read to many threads where people complain about Beloader not working with ZEN

I have no Problems at all. Neither with old method nor with new HID method.

I think problem is that in the ZEN Tutorial its mentioned that you should use USB-C Adapter for the connection Beloader/PS5 and that DIDN T work for me as well. Blinking blue light or blue/green circle.


Thought someone might benefit from the way I do connect since than:

1. ZEN Setup :
Install latest Firmware
Install latest ZenStudio

Connect ZEN to PC and open ZEN Studio :
Device Tab : Erase Memory Slots (You can keep the ones stored in Zenstudio and add them later!!)
Device Tab : Enable PS Remote Play
ZEN will restart
Check if Enable PS Remote Play is still active, if not repeat.
Remove ZEN

Shut down PS5.


2. Beloader

-setup with PSN ID and initial PS Remote play code (I use HID method with latest Firmware)
LAN Cable connected
USB cable connecteted to left side USB Port of Beloader

Connect Beloader to Front USB from PS5 WITHOUT USB-C Adapter to normal USB port
Hit the Button on the left once
Blue light starts blinkin, turns blinkin green and stops blinkin when Beloader is connected.

NOW connect ZEN to Beloader with the short usb cable from ZEN (TOP)
-NOTHING ELSE ATTACHED!
NOW connect DS5 to the LEFT USB Port of ZEN (A1)
The DS5 will start, blink and a PINK controller Light will show that anything is correctly installed

You cann add the PROG cable to the right side of ZEN and your PC
Open ZEN, Device Tab, Device Monitor and check if your inputs are registered if you like too.
Can also add scripts and gamepacks than and check if they are working in Device Monitor.

Hope this helps.


Happy shooting

Cheerz Bobbarka

Agent_Putt

Tried all the above but still doesn’t work with the zen. I can use my PS4 Controller with PS5 games if I plug my ps4 directly into the Beloader. I can’t use it with the Zen however

bobbarka

Agent_Putt replied at 2023-03-05 19:16
Tried all the above but still doesn’t work with the zen. I can use my PS4 Controller with PS5 games ...

Blue light starts blinkin, turns blinkin green and stops blinkin when Beloader is connected.

You got this step done? Or does light keep blinkin green?

You can also try A3 Port with DS4

Sero5959

I have 2023 model belwoder pro i set up with hid Manager correctyl After i connect to my ps5 it show Green After 1-2 Minutes disconnect Every Time

Agent_Putt

@sero that is incorrect. If it goes green straight away once you plug into ps5, you’ve set it up wrong. @Bobbarka I worked it out by the fact I didn’t just need to hit the reset button just once on the zen. I had to hit the reset button 4-5 times and eventually it worked

Sero5959

I use hid Manager Fro cronus with the correct Firmware . When i connect to console its Connection Remote Play After few seconds disconnecting every Time

bobbarka

Agent_Putt replied at 2023-03-06 03:36
@sero that is incorrect. If it goes green straight away once you plug into ps5, you’ve set it up wr ...

TRy to erase all Memory Slots from the Cronus from device Tab ;)

@Sero :

What happends when disconnecting? Grey light? Or again blue/green blinking?

Or just no light?

beloadermanager

Sero5959 replied at 2023-03-05 21:01
I have 2023 model belwoder pro i set up with hid Manager correctyl After i connect to my ps5 it show ...

just try https://forum.beloader.com/forum ... &extra=page%3D1

PetterRoach

Hi, čtení o tvém nastavení ZEN a Beloaderu mi připomnělo, jak jsem se minulý měsíc snažil našetřit na nový ovladač, protože ten starý už začínal být nepoužitelný. Při hledání způsobu, jak se zabavit a odpočinout, jsem náhodou narazil na spin granny a zaujalo mě, že hráči z Česká republika tam mají speciální bonusy. Zkusil jsem Aviator, nejdřív byla série proher a trochu frustrace, pak jsem zariskoval víc a trefil výhru, která mě opravdu potěšila. Od té doby to beru jako fajn relax po náročném dni a klidně bych to doporučil dál.