Beloader pro flashing red and green when plugged into ps5

EliasSawan

So i just go my beloader pro and I have done super manager and updated it and when i plug my ethernet cable into my beloader pro after i have plugged my beloader pro into the ps5 it goes blue then starts flashing red and green.

Anyone know how to fix

KroniKaL

I HAD THIS THIS MORNING


Ok start all over again reflash with firmware

restart laptop and ps5 full shut down
make sure no VPNs are on

Now open super and enter your info

then  once you have done that


connect the beloader to a power source leave the cable in the data side

Pres the left button to update

now disconnect the beloader and move cable over to power

now put in ethernet

now press the left button will turn green and connect

mickflat

I have the same issue. It was working then kept saying i was connected using remote play but controller would not move, i re installed firmware and connection but now the red, green lights.
When you press the left update button while in ps5 how long does it take and is there a light or anything to show its updating?

Thank you for any advise in advance

John_8158

Kronkial, I have same issue red / green light at same point as Eliassawan. I’ve read your instruction but don’t quite follow. Are you able to spell it out for dummies like myself by any chance ?

beloadermanager

John_8158 replied at 2022-11-09 04:28
Kronkial, I have same issue red / green light at same point as Eliassawan. I’ve read your instructi ...

need check if your ps5, pc and beloader at same router

John_8158

I have Ethernet cable gonig form pc to Router and an ethernet cable going from same router to PS5 @beloader manager